9 precautions when using the tube ice machine

1. The tube ice making machine should be installed in a place far away from the heat source, without direct sunlight, and with good ventilation. The ambient temperature should not exceed 35°C to prevent the condenser from being too hot to dissipate heat and affect the ice making effect. The ground on which the tube ice machine is installed should be solid and level, and the tube ice machine must be kept level, otherwise it will cause no ice removal and noise during operation.

2. The gap between the back and the left and right sides of the ice tube machine is not less than 30cm, and the top gap is not less than 60cm.

3. The tube ice maker machine should use an independent power supply, a dedicated line power supply and be equipped with fuses and leakage protection switches, and must be reliably grounded.

4. The water used by the tube ice machine should meet the national drinking water standard, and a water filter device should be installed to filter impurities in the water, so as not to block the water pipe and pollute the sink and ice mold. And affect the ice making performance.

5. When cleaning the tube ice maker, the power supply should be turned off. It is strictly forbidden to use the water pipe to directly flush the machine, use neutral detergent to scrub, and it is strictly forbidden to use acidic, alkaline and other corrosive solvents for cleaning.

6. The Ice tube maker must unscrew the head of the water inlet hose for two months, clean the filter screen of the water inlet valve, so as to prevent the sand and mud impurities in the water from clogging the water inlet, which will cause the water inlet to become smaller, resulting in no ice making.

7. The ice tube making machine must clean the dust on the surface of the condenser every two months. Poor condensation and heat dissipation will cause damage to the compressor components. When cleaning, use a vacuum cleaner, a small brush, etc. to clean the oil and dust on the condensing surface. Do not use sharp metal tools to clean it, so as not to damage the condenser.

8. The water pipes, sinks, storage bins and protective films of the tube ice machine should be cleaned every two months.

9. When the tube ice machine is not in use, it should be cleaned, and the ice mold and the moisture in the box should be dried with a hair dryer, and placed in a non-corrosive gas and ventilated and dry place to avoid storage in the open air.